Benefits Of Copper/Brass For Bending & Rolling: Copper is a time-honored metal that is relatively easy to work with. Available in hard and annealed tempers,. There are various types of copper tubes and pipes, including common copper alloys such as bronze and brass. Features and advantages of copper include: Thermal conductivity Malleability & ductility Corrosion […]
Beams and wide flange are both bent by BIT series section bending machine, from the very small sizes to the very large sizes. Its ability to bend wide flange and I-beam the easy way (against the weak axis) and the hard way (against the strong axis).
Stainless steel bending is a functional, aesthetic way to complete many metal design tasks. Bending is often preferable to welded or mechanical connections, as when a seamless design is required, or there is concern about the crevices created by mechanical joints. Crevices can be particularly problematic for the food and pharmaceutical industries since they may introduce contamination.
Bent steel components don’t just “walk out” of the rolling mill. Bent steel members are made of straight materials and are bent by your bending company to your requirements.
The bending process does not affect the strength or structural integrity of the steel. When the shape is successfully bent without any buckling or local cracks in the steel, under actual conditions of use, the component will withstand much less stress than that associated with the bending operation. Once the bending is completed, the member can be expected to perform as needed.
How to solve the indoor color plate condensation?Solution: make insulation layer, eliminate water vapor, and have no cold bridge indoors and outdoors 1, the cause of condensation is that the temperature of the plate is lower than the dew point (the temperature at which condensation occurs), and there is water vapor in the room. The […]
Catalogue Purpose and basic parameters of the machine Purpose of the machine W24S-75 Section Bending Machine is a three-roller profile bending machine with an arc-down type, which is a general equipment specially used for profile bending. The equipment can be used to roll profiles into circular, curved, spiral and other workpieces, widely used in petroleum, […]
Angle bending machine can complete the pre-bending, circle rolling and circle calibration process of profiles by one-time feeding; Profile bending machine has advanced structure and full functions, and can be placed upright or horizontal according to the user’s use. The structure of angle bending machine is arc downward adjusting structure, the upper roller shaft is […]
The operating regulations for the operator of the bending machine were originally an internal document of the company!
Don’t miss this free professional document.
Section bending machine (Also called profile bending machine or section bender) is Is a down-adjusting or up-adjusting bending machine. Drive of profile bending machines Three-axis structure The machine has three shafts. The upper shaft of some models is the driving shaft, and the other two shafts are the driven shafts. All three axes of models […]
Pipes and tubes are usually measured by the outside diameter dimension – or OD. One might think that a 2.0 inch OD tube would measure 2.0 inches and a 6.5 inch OD tube would measure 6.5 inches. However, machines today cannot hold dimensions precisely to the nominal value, and because of that there must be acceptable degrees of variations. In other words, every dimension on a blueprint is subject to variations from the nominal value and so is “roundness”. But “out of roundess” measurement can be contained.
