SECTION BENDING UNEQUAL ANGLE

Description

Equal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

Depending upon your unique project requirements, Profile Bending angle bending may be performed on a variety of materials, including carbon steel, stainless steel, aluminum, titanium, and copper.

Unequal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

For angle bending with heel in, the radius or diameter is usually specified as measured from the inside apex of the angle.

For angle bending with heel out, the radius or diameter is usually specified as measured from the outside apex of the angle.

When bending angles heel up, the radius or diameter is usually specified as measured from the apex of the angle.

Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.

Selection table of BIT angle bending machine for bending unequal angle

Model	Toe In		Toe Out
	Spec(mm)	Min DIA(mm)	Spec(mm)	Min DIA(mm)
PBH-120	80 × 80 × 10	1000	80 × 80 × 10	1500
PBH-140	100 × 100 × 12	1200	100 × 100 × 12	2000
PBH-200	120 × 120 × 12	1500	120 × 120 × 12	2000
PBH-300	150 × 150 × 8	1500	150 × 150 × 8	2500
PBH-360	140 × 140 × 14	1800	140 × 140 × 14	3000
PBH-450	180 × 180 × 12	3000	180 × 180 × 12	4000
PBH-500	200 × 200 × 20	4000	200 × 200 × 20	4500
PBH-550	200 × 200 × 28	4000	200 × 200 × 28	6000
PBH-600	200 × 200 × 30	4500	200 × 200 × 30	8000
PBH-700	200 × 200 × 30	4500	200 × 200 × 30	8000