The hydraulic system is the power source for the section bending of the profile bending machine, and its good working condition determines the quality and speed of the section bending. Correct use and reasonable maintenance and repair of the hydraulic system can not only extend the service life of the profile bending machine, but also reduce the maintenance cost.
the hydraulic system is an important part of the profile bending machine. It is related to the ability and accuracy of section bending.
Correct normal use and maintenance are an important guarantee for the reliable operation of the machine.
The profile bending machine needs reasonable lubrication, so as to reduce the power consumption in the section bending. At the same time it will increase the life of the machine.
For this reason, reasonable lubricating materials must be selected. Establish necessary lubrication regulations.
Shipping packaging The profile bending machine with section bending capacity less than 250CM3 is loaded in a 20-foot container. Warning:Must read before debugging Debugging PREPARATION BEFORE DEBUGGING Please check all connected and clamping parts. Please check the angle bender hydraulic… Read More »Installation and commissioning of hydraulic section bender machine
The main shaft drive and side roller lifting of the profile bending maching (also called angle roller or section bender) are all completed by the hydraulic system. The rated working pressure is 19.5Mpa.
Preface The operator should understand the structure and performance of the machine, be familiar with the operation method of the control system and the bending process of the workpiece, and strictly abide by the safety operation items. Further:Operator’s dress code… Read More »8 key requirements to ensure the safety of profile bending work
Preface Proper use of profile bending machines, careful implementation of equipment maintenance and compliance with safe operating procedures are necessary conditions for reducing machine failures, extending equipment life and ensuring safe production. Therefore, the operator and maintenance personnel of the… Read More »6 points to attention to the daily use of the section bending machine
Due to this elastic recovery, it is necessary to overbend the metal profile to achieve the required bending radius and bending angle.
The final bending radius and bending angle can be approximated from the thickness of the sheet, the K factor, the yield strength and elastic modulus of the metal profile, and the initial bending angle and bending radius.
PBH 700 profile bending machine with BIT cross-section bending combination mold can bend various profiles; the section bending machine in the picture is equipped with customized pipe molds to bend pipes, and the powerful hydraulic cylinder makes the bending of larger pipes change. It is working in a factory in the UAE.
Section bending machine (Also called profile bending machine or section bender) is Is a down-adjusting or up-adjusting bending machine. Drive of profile bending machines Three-axis structure The machine has three shafts. The upper shaft of some models is the driving… Read More »Bending process and driving mode of profile bending machine