Skip to content

Flange Forming Machine

Bending Carbon Steel Bar

Video of flat bar profile bending (flange forming)

As you can see from the video, this is a small factory. The workers are already too old.
From the control button, you can know whether the controller of the profile bending machine is the old model in the BIT series machine (the new model uses the joystick design).

Bending Angle Profiles

Section Bending Unequal Angle

Particular attention should be paid to the angle bending of unequal leg angles. You must specify short leg in, short leg out, long leg in, long leg out. Otherwise the radius or diameter of such rolled angles is usually specified as measured just as the corresponding equal leg angles.

angle bending machine

bending angle iron

What is the difference between Angle Roll Bending and Angle Bending ?
How to reduce the flat part in bending angle?
Five Factors That Influence the Bending Angle Iron Process.
Greatest Load Bearing Aspects of angle iron.
Layman’s Explanation of angle iron’s Strengths and Weaknesses.

Profile Bending Machine

W24S-100 4-roll Hydraulic Profile Bending Machine

This model W24S-100 belongs to the old model of BIT, which has now been replaced by W24S-140. This is because the processing capacity of the 140 profile bending machine covers the processing range of the 100 model.

angle flange forming

Attention point of cold bending of angle flanges

Cold bending is done on machines commonly called profile bending machine (also called angle roller or section benders) .

These machines might have three or four rolls that induce the curvature of the steel sections as they pass through the tooling.

Angle bending machine

Unequal angle bending machine

Unequal angle bending machine ( angle flange bending machine) and angle rolling machine are two names of the same machine Unequal angles are often used in tank stiffeners, matching flanges, curved lintels, hand rails, lagging rings, form work and fabricated roof trusses.

angle bending machine

Angle roller

how do angle iron roller work?
difference of the angle roller.
what you need to know before bending an angle iron?
five bending methods of angle iron.
five factors that influence the bending angle iron process.
what is angle flange ?
how to bend an angle flanges with a angle roll?
how to minimize the unbent flat of roll bending angle iron?