This article discusses the dimensions of aluminum alloy decorative strips for walls, along with corresponding knowledge points regarding the advantages and disadvantages of aluminum alloy decorative strips. We hope it proves helpful to you all, and don’t forget to bookmark our site!
Dimensions of Aluminum Alloy Embedded Parts on Wall Surfaces
Firstly, we need to establish positioning rules. The fixed aluminum alloy square pass on the wall requires measurement of the installation height and clip position, hence the positioning rules are typically made of wood and iron. Their length is generally between 1000 to 2400 millimeters; width ranges from 40 to 50 millimeters, and height depends on the type of aluminum alloy socket.
There are many types of aluminum alloys, and different types have different models and specifications. Taking aluminum alloy doors and windows as an example, the main sizes of aluminum alloy doors and windows profiles are in the 40, 450, 560, 670, 80, 90, and 100mm size series.
Embedded parts should be installed during the construction of the main structure, embedded according to the design drawings, and the embedded parts should be firm and accurately positioned. The dimensional deviation of embedded parts position: ±20mm, and the unevenness with the theoretical wall surface: ±10mm.
Reserved openings: The wall must reserve larger windows than the size of the aluminum doors and windows. Typically, add 5cm on the left and right, 5cm on top, and 5cm on the bottom to facilitate the installation of aluminum alloy doors and windows. If the reserved size error is too large and causes the aluminum alloy doors and windows to be unable to be installed, the builder should be responsible for handling it.
Installation Methods for Aluminum Alloy Edge Trim Strips on Wall Tiles
Installation methods. Construction tools for wall decoration strips include tape measures, squares, hand saws, hammers, steel nails, etc. During construction, it is necessary to verify whether the surface of the wall is flat. For irregular surfaces, it must be filled, and the plane error should not exceed five millimeters.
- Installation of General Metal Edge Trim Strips: Drill six holes with a drill bit, then insert six plastic expansion plugs, and then install special screws, or use glass glue to stick directly.
- Installation of Solid Wood Edge Trim Strips: Drill holes first, then nail directly to the wall with nails.
Plastic decorative strips are divided into pressure angle lines, pressure lines, and edge sealing lines. Their shapes and specifications are the same as wooden strips, and the fixing method for plastic decorative strips generally uses screws or adhesive. Aluminum alloy decorative strips for board walls typically include pressure lines, pressure lines, and edge sealing lines.
Next, prepare glass glue and squeeze it into the gap, also apply it to the edge strip. Then place the edge strip into the gap and press it with a heavy object for about a day. Floor edge strips have buckles and only need to be fixed to the wall edge.
Measure the wall size to determine the installation area. Based on the wall size, calculate the quantity of aluminum alloy wall panels needed. Prepare the wall substrate. The wall surface should be fully dried and stable during carbonization or painting, ensuring the wall is smooth, and the interior wall is polished and repaired. Cut the aluminum alloy panel.
